
Atomic Metal Conditioner Maximum Diesel Truck for power steering booster
9AM-5PM CST
Please wait until you receive an email confirmation that your order is ready for pickup
9AM-5PM CST
Please wait until you receive an email confirmation that your order is ready for pickup
XADO MAXIMUM Power Steering Booster for Diesel Truck is a multifunctional additive that contains Revitalizant®. It is designed to restore, repair and protect and increase of service life of power steering pump boosters and other hydraulic equipment parts, It will also improvement of lubricating properties of hydraulic fluid.
Owing to the two-component formula, Atomic metal conditioner Maximum for power Steering provides an extra level of antiwear protection and provides an exta lubricating properties of the hydraulic fluid.
Introduce the content of the Atomic Metal Conditioner Maximum Diesel Truck syringe* into the fluid, which is warmed up to the operating temperature, in the tank of a power steering booster. Start the engine and provide its idle operation during 2-3 minutes. Then turn the steering wheel during 5 minutes with the engine turned on. Drive a car as you normally do. The treatment is considered complete after the mechanism has been in operation for 50 hours or after 950 miles of run.
*1. The temperature of the compound before application should not be lower than +20…+25 0C.
2. It is recommended to preliminary dissolve the content of the syringe in a small amount (about 50ml) of used hydraulic fluid.
3. If the fluid in the tank of a power steering pump is contaminated (opaque or changed its initial color etc.) it’s recommended to change hydraulic fluid before application.
30 ml of the Atomic Metal Conditioner Maximum Diesel Truck product is enough for hydraulic system with capacity of 3-5 l. If hydraulic fluid exceeds 5 liters dosage should be increased at the rate of 30 ml for every 5 l of oil.
Syringe 30 ml XA 42016